How to start a Landoll PT-40/48

1. 1

   Turn the key one click to let the forklift run the safety screen cycle. The gauges will be set when it is complete.

2. 2

   Turn the key to start the forklift.

3. 3

   Set the idle so the forklift runs at 2500–2600 RPM for optimal operation.

How to shut down a Landoll PT-40/48

1. 1

   Idle the machine down for 30–60 seconds on low idle, then turn the key to off.

If you turn it off too soon it could vapor lock or spit out anti-freeze.

How to fix a vapor lock

PPE is required. Keep the LP line away from your skin, face, and body.

1. 1

   Shut off the LP valve on the LP tank that is connected to the forklift (there are two on board).

2. 2

   Wearing PPE, disconnect the LP line from the tank.

3. 3

   Keep that line away from your skin, face, and body, and push the nipple against the LP tank bracket until all pressure is released.

4. 4

   Turn the ignition one click so the safety screen reads the system.

5. 5

   Try to start the machine with the LP line not connected until it wants to start.

6. 6

   Leave the key on the first click and connect the LP line to the tank. Do not open the LP tank gas yet.

7. 7

   While turning the key to start, slowly open the LP tank valve until the forklift starts. If it does not start, start over, but do not exceed three tries or you will kill the battery.